\
Voltage to PWM module
\
\
This is a linear conversion module that converts the input voltage signal into the corresponding 0 ~ 100% PWM signal output through the internal chip processing.
\
There are two choices of input voltage range and two choices of output frequency.
\
\
Module parameters
\
\
1. Supply voltage: 9V to 24V
\
\
2. Input voltage range: 0.00V to 5.00V / 0.00V to 10.00V
\
\
3. Signal output frequency range: 1KHz / 8KHz
\
\
4.signalOutput duty range: 0 ~ 100%
\
\
5. Input method: J1 pad on the circuit board: open circuit (0 ~ 5V); short connection (0 ~ 10V) is open circuit by default.
\
\
6. Output mode: S1 pad on the circuit board: open circuit (1KHz); short circuit (8KHz), the default is open circuit.
\
\
7. Driving mode: open collector NPN drive, maximum current 200MA, external voltage range 1 ~ 30V.
\
\
8. Application: remote data acquisition and control equipment;
\
\
9. Size: (length) 26mm * (width) 23mm * (height) 10mm
\
\
10. Module interface:
\
\
24V: positive power connector (9V to 24V).
\
G: Power ground interface.
\
IN: Signal input positive connector.
\
G: signal input negative connector.
\
OUT: Signal output interface (1KHz / 8KHz).
\
G: Power ground interface.
\
\
Input voltage selection: J1 pad
\
Open circuit: Input (0.00V ~ 5.00V) output pulse signal with corresponding duty ratio of 0 to 100%.
\
Short circuit: input (0.00V ~ 10.00V) output pulse signal with corresponding duty ratio of 0 ~ 100%.
\
\
\
Output frequency selection: S1 pad
\
Open circuit: Output 1KHz pulse signal.
\
Short circuit: output 8KHz pulse signal.